Device
Configure Wi-Fi over USB
👋🏻 This configuration tool can only be used in Chrome, Edge, or Opera browsers on
Windows, Linux, Mac, or Chromebook. It cannot be used on phones or tablets, and
cannot be used with Safari or Firefox.
Use this page to configure any Wi-Fi enabled sensor over USB by following these steps:
- Connect your sensor to a computer using a USB cable. For more detailed instructions, see our Help Center article.
- Power up the sensor and wait for the status LED to begin blinking.
- Click the "Select Device" button and grant your browser USB permissions if needed. Select your device from the popup window - it should look something like "M-SoM - Paired".
- Once the page has loaded available Wi-Fi networks, select the network you would like to configure, enter its password if present, and click "Configure".
Once you receive a success message, your device will store the credentials and connect to the network. If you run into any issues, please read our Help Center article. If the article does not resolve your issues, reach out to support using the in-app chat.
Select a Wi-Fi network
Setup completed. Refresh page to connect another device.
Web-based device setup is not supported in this browser. Chrome, Edge, or
Opera is required. This tool cannot be used on iOS in any browser.